Take a look at the SM disassembly diagram to understand where each part is located

[shapanwwuopi]

What to do: Prepare an empty container.
Unplug the machine.
The intake hose is attached to the rear panel. Disconnect it from the housing. Place a container underneath, water may flow from the hose.
Return to the main panel.
Below the loading hatch there is a small door.
Open it.
Unscrew the filter plug counterclockwise.
Drain the water.
It is also better to immediately remove the powder dispenser. To do this, press the central latch and pull out the tray.

Move the body to the center of the room. There should be no carpet on the floor, you can just lay an unnecessary towel in case you have to turn the machine over.

How to remove the top cover ? To disassemble the equipment denmark telegram data yourself, first remove the top panel. Use a screwdriver to unscrew the two screws at the back. Move the cover away from you, remove it from its place. Immediately remove the upper counterweight. Unscrew the bolts that secure it.

Now you can turn off the control panel. Unscrew the screws around the perimeter, unfasten the latches. If you want to completely remove the panel, then pull out the wiring plugs. You can just leave it hanging on the wires.

How to remove the back cover ? Remove the screws around the perimeter of the back wall. Set it aside.

Remove the belt from the large pulley and then from the motor pulley. Now we remove the engine:

Unscrew its bolts.
Additionally, the engine is secured with two long pins. Pull them out and remove the motor from the housing.
There is a heating element located under the tank.
It is not necessary to take it out, you can take out the tank together with the element. Check the heating element with a multimeter for serviceability. If the spiral has burned out or broken, then disconnect the contacts. Then unscrew the heater nut and push the bolt inward. Pry the part with a screwdriver and remove it.